 |
| Pre-heating and metal prep before welding a large section of pipe. |
The process of pre-heating steel prior to welding is important to understand. In general, there are two primary reasons to heat treat prior to welding.
First, it increases the temperature of the target material, resulting in a controlled (slower) cooling rate of the target material, as well as that of the weld. Thicker areas of steel, typically 1/2 inch or greater, and high-strength low-alloy steels (HSLA) are prone to the formation of weakened crystalline microstructures if the weld cools too quickly. These weakened crystalline microstructures are called
martensite. Martensite is a steel crystalline structure critical to the steel's hardness and strength; too much martensite leaves steel brittle; too little leaves it soft.
When welding, martensite can form in the newly deposited weld metal, the base target material, or
the HAZ (heat-affected zone). Applying the proper amount of pre-heat prior to welding will assist in preventing the formation of martensite. Pre-heat temperatures and soak times are dependent on the target materials type, thickness, grade, and carbon equivalency. There is ample temperature and time pre-heat information available on the Internet and from industry associations, and one should refer to this information prior to welding.
Second, preheating also results in the elimination of condensation (moisture) prior to the welding procedure. The presences of moisture is problematic because the water will change phase (from liquid to gas) during welding. This phase change can releases trace amounts of hydrogen, and lingering hydrogen can be absorbed into the weld. When hydrogen molecules are trapped in the newly welded metal, they affect the metals grain boundaries and impose a risk of higher weld failure. As a result, removing moisture before welding is strongly recommended.
Uniformly preheating the target material prior to welding, and then insulating the target area after welding, provides an adequate cooling rate allowing hydrogen to diffuse out of the weld joint, preventing hydrogen cracking.
For more information about the equipment and processes required for weld pre-heating, contact
Hotfoil-EHS, a world leading manufacturer of
heat treatment equipment. They can be reached by calling 609-588-0900 or visit their web site at
https://hotfoilehs.com.
