Large, Custom Heat Treat Furnace Fabrication

The video below demonstrates the erection of a 16' x 16' x 62' heat treat furnace built out of a 6x6 I-Beam skeletal structure with 11 gauge steel skin. Full size doors, two per end, will allow the furnace to heat loads using it's full volume. The furnace is equipped with eight 3-Million BTU burners, one at either end and 3 down each side, to circulate the air. Four dampers are included, two at each end. It will move back and forth on a rail system by (16) 10" crane wheels. A hydraulic system will act to lift the furnace 3" in the air off the hearth. This will allow the furnace to move freely and without damaging the insulation on the bottom seals. It will be controlled via a remote HMI screen with full SCADA capabilities.

For more information, visit http://www.hotfoilehs.com or call 609.588.0900.